Axial-racing AX90033 Manuel d'utilisateur télécharger pdf (Page 8)

ESC Instructions

Connect the ESC wires to the motor.

Continue applying full throttle

Black

White

Red

Orange Black

Red

ESC blinks green and

emits De Le De Le De Le tone.

ESC blinks red and

emits De Le De Le De Le tone.

ESC shows no LED's and

emits De Le De Le De Le tone.

Apply full brake Set to neutral point

Green LED

De Le De Le...

De Le ...

Apply and hold full throttle on the transmitter.

Turn on the ESC and it will emit a series of tones,

De Le De Le De Le, the red and green LED will flash

then only the green LED will remain blinking.

The ESC will emit a final

short series of tones,

De Le De Le, confirming it

has been calibrated.

Plug the ESC wire into the

throttle channel on the receiver.

Before plugging the battery into the ESC.

make sure your transmitter is on

and the throttle trim is set at zero,

and the ESC switch in the OFF position.

Apply throttle to make sure the motor

is going the direction you wanted.

To reverse the direction of the motor,

switch the wires going to the motor.

Or reverse the transmitter throttle reverse switch.

Do NOT reverse the battery wire connections!

Reversing the battery polarity will permanently

damage the ESC.

Red LED

De Le De Le ... De Le De Le ...

Green LED

Red LED

No LED

OFF

TH-TRIM

If you're using NiMH or NiCd batteries turn " OFF " LiPo Cut- Off by visiting

the following link for Manually Programming the AE- 2 ESC : http: //www. axialracing. com/instructions .

(2802751)AX90033使用說明書_完稿.indd 8 2013/9/13 上午 09:48:28

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 27 28

Commentaires sur ces manuels

Pas de commentaire

Axial-racing AX90033 Manuel d'utilisateur Page 8

Commentaires sur ces manuels

Produits connexes et manuels pour Voitures Axial-racing AX90033